[Elecraft] K-3 turning on ESSB

[Dale Parfitt]

Page 36: Tap 1 to turn ESSB on.

Dale W4OP

----- Original Message ----- 
From: "Bruce McLaughlin" <bmclaugh at bex.net>
To: <elecraft at mailman.qth.net>
Sent: Thursday, January 06, 2011 4:47 PM
Subject: [Elecraft] K-3 turning on ESSB


>I have decided to try ESSB with my K-3.  I found the entry TX ESSB in the
> config menu and I set it for 3.5.  However, the word off appeared at the
> left of those figures and it did not change no matter what bandwidth I 
> set.
> I don't know whether that is correct or whether I have managed to put the
> radio in ESSB mode.  Any suggestions would be very much appreciated.  The
> owner's manual seems to suggest that the word off should change to on 
> after
> the bandwidth is adjusted.  I don't know if that is correct, and if so, 
> how
> I can do that.  Rotating the VFO A knob changes the bandwidth but does
> nothing to change off to on.  Rotating the VFO B knob causes it to go to
> another menu entry.  Thanks in advance for the help.
>
> Bruce-W8FU
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.872 / Virus Database: 271.1.1/3363 - Release Date: 01/06/11 
02:34:00