[Elecraft] [K3] K3 Utility settings for CW filters

[Dick Dievendorff]

This is in the owner's manual, and there's a corresponding table in K3
Utility Help on the Crystal Filter configuration page.

I'm afraid the table will format strangely in text e-mail.  The page is
indexed under "filter configuration". Look for the heading "Loss
Compensation".


73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Sam Morgan
Sent: Monday, January 03, 2011 4:08 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] [K3] K3 Utility settings for CW filters

I have both a 5 pole 500hz and a 5 pole 200hz cw filter.
What is the suggested setting for the db gain for those filters?

Also I remember reading a suggestion to
use the K3 utility to set the filters
slightly higher than the actual width,
example set the width of the 500hz filter to 550hz and the 200hz filter to
250hz

I have forgotten the rational for this,
can someone enlighten me, again. <g>
--
GB & 73
K5OAI
Sam Morgan
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html