[Elecraft] KX1 problems after a reset

[AB8XA]

After you are on b30, hit the RIT/2/CLR button to get b80 and then  
press/hold Edit to turn it on.
--
Moe - AB8XA
ARRL LOTW, eQSL, Fists #13020, SKCC #7460,
FPQRP #2617,  NAQCC #5352, QRP-ARCI #14326



On Feb 14, 2011, at 4:50 PM, wunger (William Unger) wrote:

> Hello:
>
> I was changing some of the settings on my KX1 in anticipation of the  
> SPAR Winter Field Day and FYBO.  I have had the KX1 with the ATU and  
> 80/30 options for several years and it worked fine.
>
> I changed a lot of parameters and was not pleased with the way it  
> was operating so I decided just to do a complete reset to the  
> factory settings and that went fine.
>
> When I turned it on I only 3 bands (when I push the band switch)  
> starting at 8, 9 and 14 MHz and I cannot tune below 5 MHz
>
> I have turned on B30 in the options and did another reset as well  
> with the same results.  I can receive between 5 and 14 MHz and  
> transmit on 14 MHz  It did operate on all bands before the reset so  
> I assume it is not a hardware or soldering problem per say.  The  
> software revision says its 102.
>
> Any ideas?
>
> Thanks,
>
> Bill VE3XT
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html