[Elecraft] KX1 problems after a reset

[wunger (William Unger)]

Hello:

I was changing some of the settings on my KX1 in anticipation of the SPAR Winter Field Day and FYBO.  I have had the KX1 with the ATU and 80/30 options for several years and it worked fine.

I changed a lot of parameters and was not pleased with the way it was operating so I decided just to do a complete reset to the factory settings and that went fine.

When I turned it on I only 3 bands (when I push the band switch) starting at 8, 9 and 14 MHz and I cannot tune below 5 MHz

I have turned on B30 in the options and did another reset as well with the same results.  I can receive between 5 and 14 MHz and transmit on 14 MHz  It did operate on all bands before the reset so I assume it is not a hardware or soldering problem per say.  The software revision says its 102.

Any ideas?

Thanks,

Bill VE3XT