[Elecraft] [K3] XV144 fault (offset problem?)

[Eric Swartz - WA6HHQ, Elecraft]

Correction - shipping is free too on this part.

:-)

73, Eric


On 2/7/2011 4:17 PM, Eric Swartz - WA6HHQ, Elecraft wrote:
> Yes, this mod adds an adjustable coil to move the newer XV144 crystals
> within the +/- 9.9 kHz calibration range of the K3. In most cases it
> will pull the crystal far enough to use an offset of zero, but that is
> not guaranteed in all cases.  There is a place already on the XV144 PCB
> for this part.
>
> We offer the XV144MDKT at no cost and the user only pays shipping. It
> should be up on the parts and mod kits order web page in the later this
> week.
>
> 73, Eric   WA6HHQ
> ----
>
>
> On 2/7/2011 11:16 AM, hb9wi wrote:
>> Hi Eric
>> I noticed that Elecraft has published two errata sheets on the transverters.
>> They mention an additional coil  L19 in series to the crystal.
>> May I order the coil at Elecraft?
>>
>> Thank you for looking into the offset problem.
>>
>> 73, Willy  HB9WI
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html