[Elecraft] [K3] XV144 fault (offset problem?)

[Eric Swartz - WA6HHQ, Elecraft]

Yes, this mod adds an adjustable coil to move the newer XV144 crystals 
within the +/- 9.9 kHz calibration range of the K3. In most cases it 
will pull the crystal far enough to use an offset of zero, but that is 
not guaranteed in all cases.  There is a place already on the XV144 PCB 
for this part.

We offer the XV144MDKT at no cost and the user only pays shipping. It 
should be up on the parts and mod kits order web page in the later this 
week.

73, Eric   WA6HHQ
----


On 2/7/2011 11:16 AM, hb9wi wrote:
> Hi Eric
> I noticed that Elecraft has published two errata sheets on the transverters.
> They mention an additional coil  L19 in series to the crystal.
> May I order the coil at Elecraft?
>
> Thank you for looking into the offset problem.
>
> 73, Willy  HB9WI
>