[Elecraft] P3 - to be or not to be - that is the question

[Bruce Beford]

The P3 does -not- need to be powered off to perform K3 firmware updates. I
believe early versions of firmware required this, but this has not been the
case for a long time. The P3 can remain on and in line. Use the P3 Utility
to update the P3, and the K3 utility (set to the same port) to update the
K3. Just remember to only run one of the utilities at a time. Simple.
-Bruce, N1RX


> Congrats on the new job!
> Yes, you can update the K3 firmware with the P3 connected, but the P3
> needs to be powered OFF.