[Elecraft] QRO = KPA500 and the KPAK3AUX

[Mike Fatchett W0MU]

There was a bit of talk on this and hopefully not having to use two y 
cables etc.  I think Elecraft said that this issue would be addressed 
with the new cable.

I hope so.

On 4/24/2011 2:09 PM, AB3EN wrote:
> Will the KPAK3AUX have a provision to tap the CTRL line?? I have the PR6
> Low-Noise 6-Meter Receive Preamplifier attached to the K3. If not can I get
> access to the pins in the connector?
>
> "When the control (CTRL) is used and jumper P2 is removed (see Figure 3),
> the K3 may be configured so
> that the preamplifier is switched on only when the 6 meter band is
> selected."
>
> Any of the Beta testers worked with issue?
>
> Dan
> AB3EN
>
> -----
>
> Dan AB3EN
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/QRO-KPA500-and-the-KPAK3AUX-tp6301471p6301471.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html