[Elecraft] [K3] No RSP for some K3 commands

[Wayne Burdick]

"ANn;" is a "SET" command. To see what the status is, you'd use the  
"GET" version ("AN;").

Another possibility is to put the K3 into autoinfo mode by sending  
"AI2;". After that, anytime you change the antenna selection either by  
sending "ANn;" or by tapping ANT on the rig itself, an "ANn;" response  
will be generated. This is true for many other commands as well. The  
programmer's reference goes into much more detail.

73,
Wayne
N6KR

On Apr 16, 2011, at 2:17 PM, Alexander Sack wrote:

> Hello Folks:
>
> Simple question, when you send the Antenna Selection command (ANn;), I
> notice that the K3 does not respond with any status code of whether it
> succeeded or not.  Is this by design or just a bug?
>
> uC 4.25
> d1 2.71
> d2 0
> fl 1.14
> dr 0
>
> I would think it should return the current a status code explicitly OR
> the current antenna selected (which then would allow an application to
> test for success, etc.).
>
> 73
>
> -aps (KC2ZSX)
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html