[Elecraft] Interface question.
iain macdonnell - N6ML
ar at dseven.org
Tue Apr 12 14:50:40 EDT 2011
I have an MFJ-998. I wish I'd known better when I bought it - I
wouldn't buy another (for various reasons). I never found a good way
to integrate it with the K3... so the tune-up procedure involves using
the K3's "TUNE" function to produce a low-power signal (CONFIG:TUNE
PWR) and then invoking the "TUNE" function on the MFJ (it's configured
in "Semi-Automatic" mode). When the MFJ finds a match (or doesn't), I
tap "XMIT" on the K3 to end the "TUNE". There is a fully-automatic
mode, where the MFJ will initiate tuning when it detects SWR above a
configured threshold, but I had bad experiences with that in the past.
If the K3 had a way to feed a signal into the ACC connector to trigger
the TUNE function, the MFJ could utilise that. The suggestion has been
made a few times, but it's probably not a high enough priority on
"Wayne's list".
Aside from the KAT-500, it appears (from their website) that PalStar
are working on a new remote-able autotuner rated for 2500W. I'm sure
it'll cost a lot more than the MFJ, but... you know what they say ;)
73,
~iain / N6ML
On Tue, Apr 12, 2011 at 12:46 PM, K2GN <k2gn at k2gn.com> wrote:
> I'm in the process of redesigning my station, inside and out.
>
> I'm going to need a tuner between the Antennas and the AMP.
>
> So, as good as the ATU in the K3 is, it won't help me.
>
> I'm looking at the MFJ-998 Auto tuner.
>
> There's no mention of Elecraft in the Manual for it, but I sure someone has
> this combo in use.
>
> To get to the point, anyone know if the Kenwood cable for the MFJ-998 works
> with the K3?
>
> Or what modification must be made to make it work?
>
> Wish the ATU-500 was coming soon.
>
> de K2GN - Larry
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
More information about the Elecraft
mailing list