[Elecraft] KX1 Red Display Filter

[Don Wilhelm]

Sorry all, I fumble-fingered the SEND button.

Sorry about the tape Chuck.  Actually, you can use anything that will 
stick it down.  If you use RTV, be careful that it does not creep into 
the display window (actually that is a good method, but not without 
hazard).  Duct tape will work, but it does harden with age.  Scotch 
transparent tape actually works quite well - get enough of the adhesive 
surface on the metal and it will stick for a long time.
Other glues that will work well are found as "Glass and Bead Glue" in 
craft stores - the same cautions as for the RTV apply.

In other words, just "get it stuck on" with a glue that will last and 
not make a mess.  Whatever is chosen must adhere to both plastic and metal.

73,
Don W3FPR

On 4/7/2011 7:49 AM, Chuck Guenther wrote:
> Instructions for installing the LED filter are given on page 52
> of the latest KX1 manual (Rev. E, dated May 21, 2010).
>
> The transparent tape just didn't hold in my case, with the result
> that the filter is floating around inside the case somewhere, leaving
> the LED display chip exposed.
>
> Has anyone discovered a better way to attach this filter?  I'm thinking
> of using a very small quantity of RTV sealant, judiciously applied
> around the edges of the filter with a toothpick.  Any thoughts?
>
> Thanks&  73,
>
> Chuck Guenther  NI0C
> KX1 s/n 2512
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>