[Elecraft] VFO Encoder doesn't change frequency

[John K3TN]

I had this problem early with my K3 and was told it is usually one of two
things: (1) a board seating problem or (2) a temperature sensitivity
problem. Since it occurred when my factory built K3 was only a few months
old, they said to send it back for warranty repair.

Of course, when it got to Elecraft the problem did not present itself. They
did temperature cycling and the problem did not occur. Likely the shipping
jostling seated the board again. Worked fine when I got it back, but the
problem did reappear once. Reseating the boards again cured the problem
again.

John K3TN

--
View this message in context: http://elecraft.365791.n2.nabble.com/VFO-Encoder-doesn-t-change-frequency-tp6237008p6238072.html
Sent from the Elecraft mailing list archive at Nabble.com.