[Elecraft] K3 Split function

[Paul Christensen]

However, QRQ split is available if there's a KRX3 installed.  There may be 
other conditions to enable QRQ mode, I don't recall.  I have programmed a 
macro to engage split.  It also adds 2 kHz to the second VFO.

Paul, W9AC

----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at embarqmail.com>
To: "Norm & Shirley Greenaway" <nwg46 at bigpond.com>
Cc: <elecraft at mailman.qth.net>
Sent: Thursday, September 23, 2010 1:27 PM
Subject: Re: [Elecraft] K3 Split function


>  Norm,
>
> Split is not available if QRQ is set on.  RIT/XIT do not work in QRQ
> mode either, but Wayne has promised a limited range RIT sometime in the
> future.  The SHIFT will not function either - see the firmware release
> notes for  version 4.03.
>
> Go to CONFIG: CW QRQ in the menu and set it to OFF and you will have
> split back again.
> If you value QRQ more than split, you will have to live with the
> limitations.
>
> 73,
> Don W3FPR
>
> On 9/23/2010 4:08 AM, Norm & Shirley Greenaway wrote:
>> Hi people
>>
>> Need help. My split function to tx on VFOB. Not function on cw. Works ok 
>> on
>> SSB
>>
>> VFO B frequency shows a + sign after and when press split says N/A QRQ
>>
>> Any ideas of what may have gone wrong
>>
>>
>>
>> Thanks
>>
>> Norm VK4NP
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html