[Elecraft] P3 question on the noise floor

[Larry K1UO]

Ross the only way I can simulate that behavior on my P3 is by disconnecting
the P3 to K3 cable.  Doing so causes the bootloader screen to come up
immediately when trying to do a ref lvl adjustment.  You may have a loose
cable or pin not making connection?

Larry  K1UO






Ross-33 wrote:
> 
> Jim, in his reply stated that the level on the screen should go down to
> -150dbm.
> As I stated in my email, whenevr I try to change the level, It comes up
> with the Boot loader screen,
> Not a lot of help.
> 
> Ideas please as I need to lower the noise floor on the P3.
> 
> Thanks
> Ross
> ZL1WN
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> 
> 

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/P3-question-on-the-noise-floor-tp5557268p5558754.html
Sent from the [K3] mailing list archive at Nabble.com.