[Elecraft] P3 question on the noise floor

[Alan Bloom]

Ross,

I think I may have missed the original message.  Anyway, if I understand
right I would suggest doing a configuration reset.  (Hold the
MENU/LABELS key wand then hold the POWER key until the Configuration
Reset message appears on the screen.)  If that doesn't work you might
try upgrading P3 firmware.  There have been some changes in the way
reference level data is saved in EEPROM.  The latest version is 00.36.

Alan N1AL


On Wed, 2010-09-22 at 13:15 +1200, Ross wrote:
> Jim, in his reply stated that the level on the screen should go down to -150dbm.
> As I stated in my email, whenevr I try to change the level, It comes up with the Boot loader screen,
> Not a lot of help.
> 
> Ideas please as I need to lower the noise floor on the P3.
> 
> Thanks
> Ross
> ZL1WN
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html