[Elecraft] New K3 & P3 Beta Firmware Available

[Bill W4ZV]

Bill W4ZV wrote:
> 
> After physically disconnecting the power plug on the rear of the K3 for at
> least 1 minute, connect the serial cable to the K3 only, turn the K3 power
> on and then try to run the Utility.
> 

I probably should have added the following (from Greg AB7R) in place of
"turn K3 on and then try to run the Utility" above:

> Starting with the power OFF.  Turn it ON but HOLD the power button for
> about 10 seconds...till you see MCU LD on the LCD.  The LCD will not be
> lit.  This is a forced MCU load state.  No using your K3 utility program
> in advanced mode, load JUST the MCU file by putting a check just in that
> box, nothing else.  Then click on send checked items to K3. 

73 & GL!

Bill
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/New-K3-P3-Beta-Firmware-Available-tp5543809p5545674.html
Sent from the [K3] mailing list archive at Nabble.com.