[Elecraft] K2 assembly Bargraph question

[Ross]

I am assembling a K2 and up to putting components into the RF board it went very well.

My question relates intially to the bar graph.
When I first tested it as shown on page 48 of the manual, the bargraph, worked perfectly, I could set
both the lo and high positions.

Now I have assembled the components into the RF board, as shown on Assembly Part 2.
Unfortunately the Bargraph no longer operates. If I go back and check Cal S lo or S hi, I do not see
anything on the bargraph.

Unfortunately the receiver is also deaf, no receive noise at all, yes the audio appears to work as I can hear the CW spot tone.


So ideas advice please..

My best wishes to Elecraft having lost Scott, he was very good to deal with.

Regards to all.
Ross
ZL1WN