[Elecraft] K3 - CONFIG question

[Tommy Alderman]

Ok Val. I just tend to go with what the designers specify and that is why I
use their specified 1 stop-bit.

73,
Tom - W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Val
Sent: Thursday, September 16, 2010 10:19 AM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 - CONFIG question

Tom,

I am using SD contest logger, where 2 stop bits were set by default for K3. 
That's why now I set N1MM on my second computer the same way. Actually 
K3-N1MM connection works fine here with 1 or 2 stop bits set, no difference.

73 Val LZ1VB



> Val -- That is good information, but why 38400/N/8/2 ? My manual says the
> stop-bits should be set to '1' ? Is your keying working with N1MM the way
> you have it?
>
> 73,
> Tom - W4BQF
> Subject: Re: [Elecraft] K3 - CONFIG question
>
> Poul-Erik,
>
> I have here K3 PTT-KEY as OFF-DTR and N1MM as 38400, N,8,2, DTR-CW,
> RTS-Always Off.
>
> 73 Val LZ1VB
>
>
>>What are the correct settings of the K3 and of N1MM for keying (CW) the K3
>>from N1MM?
>>Sorry if this has been answered in the past - if so pse just a link.
>>Poul-Erik, OZ4UN

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html