[Elecraft] K3 - Can't seem to make LINE-OUT work properly

[Don Wilhelm]

  Dan,

See the manual page 57.  If you have LIN OUT = Phones, the output level 
will be controlled by the AF Gain Control.
Set it to "nor" which will be a fixed level dependent only on the menu 
parameter value.

73,
Don W3FPR

On 9/12/2010 7:43 PM, Dan wrote:
> I am having the same problem. Hooked up to Line Out, set LIN OUT = nor 010,
> but line output still dependent on AF gain setting. Only have main RX, not
> SUB installed.
>
> Works well with fl Digi, but must set AF gain for it to work.
>
> Anyone else have any ideas?
>
> Dan, NM3A
>
>
>
> Denis Jackson-2 wrote:
>> Fairly new K3 owner here - just getting set up for digimodes.  I'm
>> probably doing something stupid but...
>>
>> I can't seem to make line-out do what it should.  I have visited "lin out"
>> in the Config menu and set a value (10) rather than =phones and yet the
>> level on the line-out jack is still dependent on the front panel AF Gain
>> control.
>>
>> Any ideas what I've missed?
>>
>> 73
>>
>> Denis MW0CBC / GW8OQV
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>>