[Elecraft] K3 RTTY

[Don Wilhelm]

  Ken,

If you were receiving him OK, your sideband selection was correct.
However, you said you were using FSK D data mode.  The polarity of your 
transmitted signal depends not only on the sideband you have selected, 
but also depends on the setting of CONFIG: FSK POL.  If you have that 
parameter set to "0", the transmit signal will be inverted.

The setting of CW rev is independent of DATA mode settings.

73,
Don W3FPR

On 9/12/2010 6:13 AM, ken chandler wrote:
> Hi Gang
>
> Have just worked VQ9LA on 15m RTTY in DATA MD, FSK D. 45 bps it decodes very
> well, using my Morse key.
>
> I tried working him for 10 minutes with 100w, he then works me and told me
> I'm in reverse mode and he twigged as he knew I was calling so he went
> reverse his end and worked me.
>
> I have not selected reverse mode on my K3
>
> The radio is in DATA and LSB.
>
> After the qso I pressed the MODE button and noticed that CW was in REV ie
> rev cw, would this throw the RTTY into reverse mode.
>
>