[Elecraft] K3 - FW Version 4.12/CONFIG:TX DVR Ind setting

[Fred Jensen]

I just installed Version 4.12, everything went as it should, I 
power-cycled the K3.  In CONFIG:TX DVR, I set it to IND.  Holding the 
CMP/PWR gives me the usual monitor tone [I'm on CW] adjustable by the 
knob.  Holding it a second time turns the tone off but leaves the MON 60 
n the display.  Holding it multiple times after that does nothing, 
doesn't turn the tone on, doesn't change the display.  A tap gets me 
back to normal.

The release notes, if I'm reading them correctly, say that the second 
hold should switch to DVR xx, and subsequent holds should toggle back 
and forth between MON and DVR.  This has to be pilot error.  Any help?

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2011 Cal QSO Party 1-2 Oct 2011
- www.cqp.org