[Elecraft] [K3][P3] No data decode in K3 Utility?

[Alan Bloom]

Currently the K3 Utility's text decode display does not work when the P3
is turned on.  That is because it uses the old K3 "TT" (Text to
Terminal) command which is not supported by the P3.  K3 Utility is going
to be modified to support the new "TB" (Buffered Text) command so that
it can display text with the P3 connected.  (TB actually works better
than TT even without the P3.)  I'm not sure what the time frame is for
that.  Perhaps Dick can comment when he returns from vacation.

Alan N1AL


On Tue, 2010-10-05 at 12:12 -0500, Oscar Staudt wrote:
> When P3 is turned off, I start the K3 Utility, and I will see my text decode
> data (both CW and PSK) in the VFO B window, and in the K3 Utility Terminal
> window.  However, when the P3 is turned on, the data is still shown in the
> VFO B window, but does not show up on the K3 Utility Terminal screen.
> 
> K3:  4.112
> P3:  00.36
> 
> I thought I read something about this on the reflector recently, but I've
> been searching and can't find it.  I don't remember if this was a firmware
> glitch to be fixed, or ...?
> 
> Thanks gang!
> 
> Oscar, WB5GCX
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html