[Elecraft] turn off head phone monitoring

[Amateur Radio Operator N5GE]

Yes.

Here's how you do it...

Hold the Menu/Config button.

Turn the VFO B knob until you see SPKR + PH in the lower right hand portion of
the display.

Turn the VFO A knob until you see the setting you want (YES or no).  If you set
YES you will have speaker AND Phone output.  If you choose no you will only have
phone output.

Tap the Menu button to return the display back to the VFO's.

The instructions for this are on Page 20 of the Revision D7 K3 User's Manual.
Keep a copy of the latest PDF file on your desk top for quick reference.  It has
a good search feature at the top just right of the center.

73,

Tom Childers
Radio Amateur N5GE
Licensed since 1976
QCWA Member 35102
ARRL Life Member



On Tue, 23 Nov 2010 07:46:01 +0000, Ian White GM3SEK <gm3sek at ifwtech.co.uk>
wrote:

>N5GE wrote:
>>There is no switch to turn the monitor on or off.  If you don't want to 
>>here it set it to zero.
>>
>
>There are many situations such as club, contest and special event 
>stations where a loudspeaker is needed for RX, while the operator also 
>needs a low-level monitor signal into the headphones for TX.
>
>Is there any way to switch off the monitoring feed to the speaker(s) to 
>avoid feedback, while leaving it available as usual in the headphones?
>
>It is always bad practice to monitor a live microphone transmission 
>through a  speaker, because even low levels of acoustic feedback will 
>affect the signal quality. The default for all voice modes should be to 
>mute the LS channel automatically while transmitting.