[Elecraft] K2 #6950 - Alignment 2, VCO and BFO issues

[Steve KC8QVO]

I went through the trouble shooting list here in the back of the manual and
found my VCO output (pin 3 of U3) to fluctuate between .08-1.33v. Also, the
BFO output (pin 6 of U11) shows .136-.2v. Both measurements were done with a
DMM and the probe kit. 

Any ideas? 

With Alignment II my PLL Reference high freq is 12003.17 and the low freq is
11990.48, range = 12.69. The BFO freqs are: high=4916.87, low=4912.16,
range=2.71. 

Another quick question about adjusting C22 using another radio - I turned
C22 both directions and found it would peak the sidetone frequency/intensity
heard on the radio at one point and either direction beyond that the tone
and volume dropped off. I went counter clockwise, using headphones, until I
couldn't hear any tone and bounced between LSB and USB to make sure I
couldn't hear anything (low freq rumble) in either mode. Did I do this
correctly?  

Steve, KC8QVO
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K2-6950-Alignment-2-VCO-and-BFO-issues-tp5119230p5119230.html
Sent from the Elecraft mailing list archive at Nabble.com.