[Elecraft] K3? KXV3A RX Ant, IF Out & Xvrtr Int question using LP-PAN, w/ Rev. B RF board

[Iain MacDonnell - N6ML]

On Wed, May 26, 2010 at 6:08 PM, dbp tds.net <dbp at tds.net> wrote:
> Hi-
>  I read that K3 RF boards (Rev. H3 and later) sold about 09/01/09 had
> a different value resistor, somewhere on the RF board that allowed for
> a 10dB increase in signal to the I.F. output for use with LP-PAN and
> other panadapters.  My RF board is a rev. B.
>  Elecraft has a kit with the correct resistor, its order number is K3IOBUFFKT.
>  Does anyone happen to have the value of the resistor and Elecrafts'
> directions as to where it goes? I don't want to wait for Left Coast
> time if I don't have to.

Dave,

See: http://www.elecraft.com/K3/mods/IF_Output_Buffer_Gain_Mod_Rev_A.pdf

GL,

    ~Iain / N6ML