[Elecraft] K3 Sub-receiver use

[hb9ari]

Hi Doug,

Thank you for your reply !

As answered to Richard, i've done the bad
choice when ordering a P3!
My "bad" idea was to connect him to
a "future" KRX3 !!
Fortunately it was not too late to
stop my order ! But for the P3...

My best 73,
Rudolf, HB9ARI

Doug Joyce wrote:
> Rudolf:  The IF output from the K3 is from the main receiver not the 
> sub receiver.  If you check back in the archives, there are some 
> articles relating to getting an IF sample from the Sub RX.
>
> 73,  Doug   VE3MV
> K3/100  s/n 2432
>
>
> ----- Original Message ----- From: "hb9ari" <hb9ari at bluewin.ch>
> To: "Elecraft-forum" <Elecraft at mailman.qth.net>
> Sent: Tuesday, May 25, 2010 5:52 AM
> Subject: [Elecraft] K3 Sub-receiver use
>
>
>> Hello,
>>
>> Before to order a sub-receiver for my K3 (#1212),
>> i would know if the primary use i've envisaged is possible:
>>
>> RX/TX on main receiver on 20m for example, with
>> output power between 5 and 75W (JT65A mainly).
>> Sometimes, the auto-tuner in the K3 is used.
>>
>> RX  on sub-receiver for 6m on a separated antenna,
>> (Preampli 6m Elecraft ON or OFF)  and IF output to
>> the (ordered ) P3 for band monitoring.
>>
>> Thank you for information, because i'm not
>> clear with  hardware and firmware version
>> necessary for this "dual" band use.
>>
>> My best 73,
>> Rudolf, HB9ARI
>>
>>
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>
>