[Elecraft] [Elecraft_K3] K3 Firmware Rev. 3.97: new DSP NB algorithm, improved TX INHibit, accurate S-meter w/AGC off, etc.

[Don Wilhelm]

Lance,

Add a bit of decode logic to the band outputs to decode the bands of 
interest to you, and use the output to activate the TX INH for that band.
Yeah, I know it is not internal, but it is so easy to do.  I don't think 
there are many out there with this specific requirement.

73,
Don W3FPR

Lance Collister, W7GJ wrote:
> TNX for the explanation on the TX INHIBIT.  Yes, it seems to work here ;-) However, 
> it it too bad it is not remembered by band so it would automatically go into effect 
> when one switches to a band where a separate XMTR is being used :-(  For example, 
> that is the setup here on 2m, using a separate receive converter fed into the K3, and 
> a 100w IC746 as the XMTR.  In the meantime, I have the 2m xnsverter output turned all 
> the way down in power and terminated in a 50 ohm resistor.
>
>