[Elecraft] [Elecraft_K3] K3 Firmware Rev. 3.97: new DSP NB algorithm, improved TX INHibit, accurate S-meter w/AGC off, etc.

[Vic K2VCO]

On 5/18/2010 12:19 PM, David Ferrington, M0XDF wrote:
> Wayne, does this meen I can't here the keyer when I'm in TX INHIBIT?
>
> I use it as a way of practicing my keying, which isn't up to much yet, but if you've
> stopped the feedback, I can't do that any more.
>
> Also, it means I can't check my monitor level before going into VOX!

Remember that TX INHIBIT is not the same as TX TEST. What you get when you hold the right 
side of the Mode button is TX TEST, in which the tones are not disabled.

TX INHIBIT is activated by either raising or lowering a control line connected to the 
accessory plug, and is used for such things as sequencing in moonbounce setups, etc.
-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/