[Elecraft] [K2] VCO Test

[Clark Ward Jr]

I got discouraged after having more than a few issues with my K2 and
have returned to finish the project now that I'm not eyeballs-deep in
nursing school.

I'm in 'Alignment and Test, Part II' in the VCO Test.  Everything is
good up through this point (Having started anew, I reperformed all
calibration and alignment steps up to this point).

I have the frequency probe plugged into P6, and TP-1, the VFO set to
4000.10 kHz, and used the menu to have the freq counter active.

The display shows zeroes all the way across, where it should show
something between 8 and 10 MHz.  Any guidance on places to look is
gratefully accepted.

-- 
KI4GYT Clark in Georgia