[Elecraft] K2 Not Talking to Computer

[Don Wilhelm]

Lou,

If you can communicate in any way with the K2 (and you *can* because you 
said the frequency is displayed in N1MM), then the KIO2 is enirely 
capable of communications.  Look at the software application setup for 
the problem.
You might try putting the RTS/CTS jumper on the connector at the 
computer end.  Even if your application does not use it, the jumper will 
do no harm

73,
Don W3FPR

Louis Visconti wrote:
> I'm sure this question has been answered before, if someone could point me 
> in the right direction, I would appreciate it.
> PC and K2 not talking. K2 Port ON; Computer-4800 baud, 8 data bits, no 
> parity, 2 stop bits. Cable connections look good, RTS/CTS Loopback not used. 
> Trying to use this setup with N1MM Logger. I can see the transceiver 
> frequency in the software and it does respond to frequency changes and band 
> changes, but thats all. Do I now check the voltages on the KIO2, or is there 
> another place to look first?
>   
>