[Elecraft] K3 Quick Split Operation?

[Wes Stewart]

You can do it with a macro.

But with XIT available, why bother?  Turn on XIT, dial up the split you want and there you are.  If you want to listen to your TX freq, press "RIT".

You can set the display for continuous readout of the offset in the "B" location by tapping "DISP" and setting the B knob to display the position between the date and the voltage.  You lose the "fast/integer" tuning capability of the offset knob by engaging this, however.

--- On Sun, 3/21/10, AC6JA at aol.com <AC6JA at aol.com> wrote:

> From: AC6JA at aol.com <AC6JA at aol.com>
> Subject: [Elecraft] K3 Quick Split Operation?
> To: Elecraft at mailman.qth.net
> Date: Sunday, March 21, 2010, 11:48 AM
> I've been searching the archives and
> can't find any quick and easy way to  
> "UP 1" for Quick Split operation.
> The only way I see doing it is hitting the A>B button,
> then hitting  SPLIT, 
> and dialing in the frequency 1 khz above the VFO A
> frequency into VFO B  
> using the VFO B knob.  Is there any easier way?
> My Icom 756 ProIII has a way to go "UP 1" by holding the
> SPLIT button and  
> then hitting "1" and hitting SPLIT again.  Or hitting
> "2" to go up "2",  etc.
> Maybe this is something that can be added in a future
> firmware  release?
> Any info would be appreciated.
> Thanks.
> 
> Mike  AC6JA
> K3 #3215