[Elecraft] K3 ver 03.79 and Palstar AT-AUTO

[Mike]

Mine(1.2.3.14) has NEVER failed to return the K3 to its pevious 
settings. Which version of the utility are you using? How does the 
Palstar hook up to the K3?

73, Mike NF4L

Bill Miner wrote:
> FYI
>  
> Just in case someone else has this same problem,   I loaded the latest K3 firmware onto my rig and when the load was complete I found that my K3 would no longer control the Palstar tuner.
>  
> It seems that the K3 Utility does not return the RS-232 port back to the original baud speed setting that was used before the down load when it is finished.  After I reset the RS-232 port speed back to the original 9600 setting then the Palstar tuner started tracking again. 
>  
> 73,
> Bill - K6WLM
> KX1, K2, K3-100k
>
>
>       
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>