[Elecraft] K3 ver 03.79 and Palstar AT-AUTO

[Bill Miner]

FYI
 
Just in case someone else has this same problem,   I loaded the latest K3 firmware onto my rig and when the load was complete I found that my K3 would no longer control the Palstar tuner.
 
It seems that the K3 Utility does not return the RS-232 port back to the original baud speed setting that was used before the down load when it is finished.  After I reset the RS-232 port speed back to the original 9600 setting then the Palstar tuner started tracking again. 
 
73,
Bill - K6WLM
KX1, K2, K3-100k