[Elecraft] PR6 SubRec and two bands at once on K3

[Bill K9YEQ]

Brett,

Thank you for the response.  I haven't considered the use of the pass through BNC's.  I want to use the Sub Rec and the 6 meters and be able to switch back and forth to transmit on any 160-6 meter freqs.  

Bill
K9YEQ


-----Original Message-----
From: Brett Howard [mailto:brett at livecomputers.com] 
Sent: Monday, June 28, 2010 1:35 PM
To: Bill K9YEQ
Cc: Elecraft
Subject: Re: [Elecraft] PR6 SubRec and two bands at once on K3

How are you selecting to enable your PR6?  Are you using the DIGOUT line?  If so you should be able to see what is going on by looking at the DIGOUT line.

You will need the RX ant enabled in order to use the PR6.  The PR6 is inserted into your RX_ANT loop when its enabled.  Otherwise it simply passes those through to the BNC's on the other side.

~Brett (N7MG)

On Mon, 2010-06-28 at 13:01 -0500, Bill K9YEQ wrote:
> Seems when I have the Sub Receiver set on 6 Mtrs and the main band on 
> 75, the PR6 isn't getting the signal through the RX.  Or do I not need 
> the RX on to use the PR6, or is the PR6 out of circuit when in this configuration?
> 
>  
> 
> Bill
> 
> K9YEQ
> 
> K2 and KX1 field tester, K3 and modules
> 
>  
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net Please help support this email 
> list: http://www.qsl.net/donate.html