[Elecraft] PR6 SubRec and two bands at once on K3

[Brett Howard]

How are you selecting to enable your PR6?  Are you using the DIGOUT
line?  If so you should be able to see what is going on by looking at
the DIGOUT line.

You will need the RX ant enabled in order to use the PR6.  The PR6 is
inserted into your RX_ANT loop when its enabled.  Otherwise it simply
passes those through to the BNC's on the other side.

~Brett (N7MG)

On Mon, 2010-06-28 at 13:01 -0500, Bill K9YEQ wrote:
> Seems when I have the Sub Receiver set on 6 Mtrs and the main band on 75,
> the PR6 isn't getting the signal through the RX.  Or do I not need the RX on
> to use the PR6, or is the PR6 out of circuit when in this configuration?
> 
>  
> 
> Bill
> 
> K9YEQ
> 
> K2 and KX1 field tester, K3 and modules
> 
>  
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html