[Elecraft] Heil HC-5 & K2

[Bill K9YEQ]

Don,

I thought one could listed to audio from the mic using a front panel switch.
It has been a few years since I did this.  I need to do it again so before I
try it again on a new mic, what is it that one is monitoring when using the
function?


73,

Bill
K9YEQ


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wilhelm
Sent: Tuesday, January 19, 2010 12:14 PM
To: n0jrn
Cc: Elecraft
Subject: Re: [Elecraft] Heil HC-5 & K2

Jerry,

The K2 has no provisions for monitoring the transmitted audio.  A 
separate receiver works well.  I keep one at the workbench specificall 
so I can check the transmitted SSB signal after I align the filters on a 
K2 - that is about the only use my Yaesu FT-900 sees anymore.

73,
Don W3FPR

n0jrn wrote:
> Along this line !
>
> Does the K2 have a monitor circuit built in or does one need a separate 
> receiver to check clarity ???
>
> I find no reference to monitoring the transmitting voice in the K2 manual 
> but wanted ask anyway.
>
> 72         Jerry          N0JRN
>
>   
>