[Elecraft] K2 Control board resistance checks

[Don Wilhelm]

Paul,

Yes, those are OK.  They are the DOT and DASH lines to the 
microprocessor and have nothing else but U6 on the Control Board to 
bring the resistance down.

In general, a 10% deviation from the values listed in the manual are 
close enough.

73,
Don W3FPR

Paul Huff wrote:
> Hi everybody,
>
> I recently started building a K2 and I've just finished the assembly of the 
> control board.  My resistance checks are all within specs except two of them are 
> just a little bit off.  My readings at pins 29 and 30 of U6 are a little bit 
> higher than those listed in the table.  (I'm getting about 96.3 K and the table 
> lists 70-90 K.)  I think that these readings are probably OK, but I thought that 
> I would ask someone who has "been there and done that."  Is there any need to be 
> concerned about these checks?
>
> Thanks in advance and 73,
> Paul - N8XMS
>   
>