[Elecraft] K2 Control board resistance checks

[Paul Huff]

Hi everybody,

I recently started building a K2 and I've just finished the assembly of the 
control board.  My resistance checks are all within specs except two of them are 
just a little bit off.  My readings at pins 29 and 30 of U6 are a little bit 
higher than those listed in the table.  (I'm getting about 96.3 K and the table 
lists 70-90 K.)  I think that these readings are probably OK, but I thought that 
I would ask someone who has "been there and done that."  Is there any need to be 
concerned about these checks?

Thanks in advance and 73,
Paul - N8XMS