[Elecraft] [K3] IF output

[srife at swbell.net]

	I thought about that and I guess that must be the case.


Stan Rife 
W5EWA 



-----Original Message-----
From: Joe Planisky [mailto:jplan at jeffnet.org] 
Sent: Tuesday, January 12, 2010 3:57 PM
To: srife at swbell.net
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] [K3] IF output

I don't think you'll hear much of anything on a K2 at 8.215 MHz.  
That's well outside the 40m passband.  The K2 does not have general  
coverage RX.

73
--
Joe KB8AP

On Jan 12, 2010, at 1:05 PM, <srife at swbell.net> wrote:

> 	I am trying to verify the output at the IF OUT jack on the back of
> the K3. I have it connected to my K2 with the VFO set for 8215.00  
> and I see
> or hear no signal at all. Shouldn't I see the output from the K3? Is  
> the
> signal that low that I won't even get a blip on the K2 receiver? Am I
> missing something? I see no menu entry for enabling the IF output.   
> HELP
>
>
> Stan Rife
> W5EWA
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.725 / Virus Database: 270.14.136/2616 - Release Date: 01/12/10
01:35:00