[Elecraft] [K3] IF output

[Joe Planisky]

I don't think you'll hear much of anything on a K2 at 8.215 MHz.  
That's well outside the 40m passband.  The K2 does not have general  
coverage RX.

73
--
Joe KB8AP

On Jan 12, 2010, at 1:05 PM, <srife at swbell.net> wrote:

> 	I am trying to verify the output at the IF OUT jack on the back of
> the K3. I have it connected to my K2 with the VFO set for 8215.00  
> and I see
> or hear no signal at all. Shouldn't I see the output from the K3? Is  
> the
> signal that low that I won't even get a blip on the K2 receiver? Am I
> missing something? I see no menu entry for enabling the IF output.   
> HELP
>
>
> Stan Rife
> W5EWA
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html