[Elecraft] K3 and N1MM Logger

[Tommy Alderman]

Thanks Jim, but that is NOT the problem. I have had both the serial port and
K3's RS232 set to both 19200 b and also 38400 b and get the same results. 

I initially had the problem because my serial port was set to 19200 b and my
K3's RS232 was set for the default of 4800 b. After I changed RS232 to 19200
b, the K3 and N1MM communicated excellent. AFTER updating the K3 firmware to
4.03, again, the K3 and N1MM would not communicate. 

I am in the process of reverting the K3 firmware back to 3.xx.

Thanks Jim and 73,

Tom - W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jim Brown
Sent: Tuesday, August 03, 2010 2:16 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 and N1MM Logger

On Tue, 3 Aug 2010 12:28:54 -0400, Tommy Alderman wrote:

> It was working just fine right after I reset the
>RS242 to the correct (19200 b) baud rate; then I updated to the beta 4.03
>firmware and now it does not talk to N1MM again.

That's the problem. You must set BOTH the K3 and N1MM to the SAME baud rate.

Changing it is what made it spit up. Like Guy, I use 38,400. Slower speeds 
also work. 

73, Jim K9YC



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html