[Elecraft] RE: Current K144XV Firmware Revisions

[Roger Dallimore]

Fantastic! That was it, just didn't go through all the menus and missed 
the int bit.

Many thanks David,

73
Roger  MW0IDX

K3 #191
K2 #2724
KX1 #416

David Johnson wrote:
> Roger,
>
> Make sure that you have selected the Internal (INT) transverter option 
> in the Menu, this activates the KX144. If it is set to EX the K3 looks 
> for an external unit. Once I went through the Menu for the 2nd time 
> when my unit failed to work first time I realised I had not selected 
> the INT correctly. Good luck,
>
>
> 73, David G4DHF
> www.g4dhf.com <http://www.g4dhf.com>
>
>
>
>
>     ========================================
>     Message Received: Apr 23 2010, 09:27 PM
>     From: "Roger Dallimore"
>     To: Elecraft at mailman.qth.net
>     Cc:
>     Subject: [Elecraft]  Current K144XV Firmware Revisions
>
>
>     Can someone tell me what the latest K144XV Beta/Full release
>     version is
>     please? Can't see anything other than version 1 on the software page.
>     Tried clearing the cache etc.
>
>     Can't get tx or rx to work. When I performed the frequency
>     calibration, selecting Config- XV1 OFS, I do not see either of the
>     two
>     offset ranges 144 or 146 to the left of the KHz displayed or a way to
>     change between the two segments. Hope that made sense.
>
>     Can some kind person enlighten me to what I am doing wrong please
>     before
>     I pull all my hair out! (status light showing nothing wrong)
>
>     TIA & 73
>
>     Roger MW0IDX
>
>
>
>     ______________________________________________________________
>     Elecraft mailing list
>     Home: http://mailman.qth.net/mailman/listinfo/elecraft
>     Help: http://mailman.qth.net/mmfaq.htm
>     Post: mailto:Elecraft at mailman.qth.net
>
>     This list hosted by: http://www.qsl.net
>     Please help support this email list: http://www.qsl.net/donate.html
>
>
>
>