[Elecraft] KPA500

[Gary Gregory]

All,
One would assume ( there's that word again) it would be jumpered for
120/240VAC as Elecraft sell worldwide.

I would also think it will be built around MRF-150 FET's?

IMD numbers should be good also.

Gary
VK4FD


On Sat, Apr 17, 2010 at 6:40 AM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> David,
>
> Because not all have hamshacks that are wired for 220 volts.  If the
> space was not wired specifically for hamshack use, there is likely to be
> only 120 volt receptacles available.   Up to 1000 watts draw (500 watts
> with 50% efficiency) on a normal 120 volt 15 amp circuit is practical,
> but attempting to run more than becomes marginal.
>
> 73,
> Don W3FPR
>
> David Ferrington, M0XDF wrote:
> > I'm intrigued, obviously we'd look for 220v over here, but why not 120v
> in US?
> > 73 de M0XDF, K3 #174
> >
> >
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 
Gary
VK4FD - Motorhome Mobile
http://www.qsl.net/vk4fd/
K3 #679
For everything else there's Mastercard!!!