[Elecraft] k2 assembly next question.

[Don Wilhelm]

I am not sure where you read any reference to Figure 5-15.
All the reflector posts responding to your question referred to Figure 
5-11.  It is on page 28 (the only figure on that page).

You will get to the part of the build where the front panel and control 
board are mounted to the RF board on pages 41 and 42.
In the meantime, you should have two standoffs mounted on the solder 
side of the Front Panel board - just make sure they are in place before 
putting the metal on the Front Panel Board and mounting the knobs.

73,
Don W3FPR

Foxjazz wrote:
> Hello Elecraft,
>
>   figure 5-15 doesn't look anything like the front panel assembly
>   elecraft k2.
>  
>   Also the gree led cover double-sided tape was 1 sided second part
>   didn't peel off. So I used glue.
>
>   I don't understand how the front panel is attached to the control
>   board.
>   
>