[Elecraft] k2 assembly lcd

[lstavenhagen]

Are you sure you have the correct spacing? I.e. the 2 spacers stacked on top
of each other (flatwise) should fit perfectly under each end of the diffuser
and everywhere underneath it. 

The instructions for my LCD were completely spot-on. The leads for the LCD
should just barely go into the holes as-is or even almost float above them
(this is why you solder them from the component side of the board and not
the bottom). That was exactly the case with mine, the leads were almost but
not quite flush with the bottoms of the holes on many and some they were
just barely going in......

73,
LS
W5QD
-- 
View this message in context: http://n2.nabble.com/k2-assembly-lcd-tp4841250p4842897.html
Sent from the Elecraft mailing list archive at Nabble.com.