[Elecraft] Transmit on VFO B

[Don Wilhelm]

Olli,

Sorry for the 2 day old response, but I did not see any other answers to 
your question.
The transmit stages are associated with the main receiver - they cannot 
be associated with the sub-RX.

If you have VFO A on a different band than VFO B, without the sub-RX you 
cannot listen on the VFO B frequency, so I conclude that you have the 
sub-RX because transmitting without listening is poor practice that no 
decent ham would do IMHO.

It is a simple matter to transmit on the band that VFO B is set to - 
simply tap A/B to swap the VFOs and you are ready to transmit on the 
frequency/band that was previously set in VFO B - only now it is in VFO A.

This method may be different than you had with your TS-850 and N1MM, but 
the capability is there - just tap A/B (or have N1MM do it).

73,
Don W3FPR

Oliver Grossmann wrote:
> Me again,
> i forget, Tx on VFO B if VFO B is on different Band.
>
> 73 Olli, DH2WQ
>
> ------------------------------------------------------------------------
>
> Oliver Grossmann | DH2WQ | oliver.grossmann at bretzi.de
>
>
>
> Oliver Grossmann wrote:
>   
>> Hi,
>> I know it was discussed before, but i haven't found a final statement in 
>> the archives of the List.
>> My last info is it is impossible to Transmit on VFO B during Output 
>> Filter Switching and QSK.
>>
>> I'm not sure if somebody ask to switch off QSK in this split mode.
>> Are there any plans to have such a feature in the future? (I really like 
>> this on my TS-850 in combination with N1MM)
>>
>> Thanks Olli, DH2WQ
>>     
>