[Elecraft] K3 Audio Response - Version 3.33 Firmware

[Brett Howard]

Ah yes it does look like that is the case.  Went back and read it and it
clearly states (there are some limitations at present).  Thats somewhat
of an esoteric one...  Wonder if at some point it can be supported.
Seems like it was a difficult one to figure out at the time so rather
than dig into that section of and update it to support the new shift it
was just disabled.  Its been fun watching this thing grow...

~BTH 

On Sun, 2009-09-20 at 06:07 -0700, Lyle Johnson wrote:
> > With the latest 3.33 pre-released test I am unable to set the top two
> > knobs to HI/LOW adjustments.  However this problem is only present when
> > the radio is in the CW mode.  When in this mode tapping the HI/BW knob
> > doesn't change it between modes.  
> >   
> 
> When CONFIG PB CTRL CHIFT=.01 you can;t use HI CUT/LO CUT> IF SHIFT=.05 
> (default), then you can.  See Release notes for 3.25/2.21.
> 
> 73,
> 
> Lyle KK7P
>