[Elecraft] VOX behaviour changed with new firmware?

[Greg]

Dick,

This has always been the designed behavior.  When operating CW and you do 
NOT want to assert PTT either manually or by computer then VOX must be ON. 
When it is off, you must assert some PTT for RF to pass.

73
Greg
AB7R

----- Original Message ----- 
From: "PA3CW" <pa3cw at planet.nl>
To: <elecraft at mailman.qth.net>
Sent: Saturday, October 10, 2009 9:46 AM
Subject: [Elecraft] VOX behaviour changed with new firmware?


>
> As almost 'CW only'  operator I experience that sometimes after some 
> switch
> combinations or switching on the K3, I have no output due to the VOX not
> being activated. After pressing VOX once this is solved. I did not have 
> this
> behaviour with earlier firmware versions.  Are there others who have the
> same experience?
> Further enjoy the K3, it's firmware updates and the discussions on Nabble!
> Just super.
> Best regards,
> Dick PA3CW
> -- 
> View this message in context: 
> http://n2.nabble.com/VOX-behaviour-changed-with-new-firmware-tp3800382p3800382.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.421 / Virus Database: 270.14.9/2426 - Release Date: 10/09/09 
18:43:00