[Elecraft] VOX behaviour changed with new firmware?

[PA3CW]

As almost 'CW only'  operator I experience that sometimes after some switch
combinations or switching on the K3, I have no output due to the VOX not
being activated. After pressing VOX once this is solved. I did not have this
behaviour with earlier firmware versions.  Are there others who have the
same experience?
Further enjoy the K3, it's firmware updates and the discussions on Nabble!
Just super.
Best regards,
Dick PA3CW
-- 
View this message in context: http://n2.nabble.com/VOX-behaviour-changed-with-new-firmware-tp3800382p3800382.html
Sent from the Elecraft mailing list archive at Nabble.com.