[Elecraft] [K3] K3 in SS SSB
Joe Subich, W4TV
lists at subich.com
Wed Nov 25 09:26:14 EST 2009
> When you put your K3 in split mode, does the word "Split"
> appear to the right of the "Buck" button in the N1MM Logger
> entry window?
No. N1MM Logger 9.11.0
73,
... Joe, W4TV
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Iain
> MacDonnell - N6ML
> Sent: Wednesday, November 25, 2009 2:18 AM
> To: Barry N1EU
> Cc: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] [K3] K3 in SS SSB
>
>
> On Tue, Nov 24, 2009 at 12:54 PM, Barry N1EU
> <barry.n1eu at gmail.com> wrote:
> > On Tue, Nov 24, 2009 at 6:12 PM, Iain MacDonnell - N6ML
> > <ar at dseven.org> wrote:
> >>>>
> >>>>
> >>>>> Whether or not the K3 CAT API has been enhanced to make
> it easier
> >>>>> to read the split state, Logger isn't supporting it yet.
> >>
> >> FWIW, I tried this N1MM Logger feature last night - I hadn't paid
> >> attention to it before. It seems to work fine. I put the K3 into
> >> Split mode with the buttons on the front - not via N1MM
> Logger, and
> >> it was detected correctly. I didn't run a 48 hour contest with it,
> >> but a quick test seemed to suggest it works well.
> >
> > I'm not sure which Logger feature you tried Iain, but 9.11.0 is the
> > latest and "Reset RX freq to TX when QSO is logged (RUN &
> Split)" is
> > NOT working if you manually put the K3 into split mode,
> call cq, tune
> > off freq to pick up a caller and log the qso. VfoA will
> stay off freq
> > instead of being matched to vfoB as it should and as it
> works on other
> > radios.
>
> Don't know why it's not working for you - works fine for me.
> I'm using K3 firmware revision 2.63 and N1MM Logger V9.11.0.
> I do have LP-Bridge in the middle. Perhaps that's actually
> helping it to work?? I'll try without at some point.
>
> When you put your K3 in split mode, does the word "Split"
> appear to the right of the "Buck" button in the N1MM Logger
> entry window?
>
> ~Iain /N6ML
More information about the Elecraft
mailing list